Zoom to 1200%
Wheel and pinch zoom, a jump straight to the detail, and a frozen frame to study it.
HomeBLACKLENSBLACKLENS 3.3
The inspection studio · version 3.3
The software behind every BLACKSCORE. It drives the stage and the camera, stitches the card together, measures it, records every flaw — and publishes the report the moment the inspection is done.
Every card follows the same path through the studio, under its own Job#.
The card lies still on a motorised XY stage while a 4K camera photographs it in 16, 36 or 42 overlapping shots per side. BLACKLENS stitches them into one full-card image of tens of megapixels and levels it against a steel square. Since 3.1 it reads through sleeves, card savers, toploaders and graded slabs too.
An outer frame is snapped to the card’s edge and an inner frame to its printed border. A centering grid in half-millimetre steps runs between them, so a border of 3.89 mm reads as 3.89 mm — on the front and on the back.

The inspector works on the live view with the full 4K card mapped beside it, so every mark lands on the right spot of the card. Every card, every time, by a person.
Wheel and pinch zoom, a jump straight to the detail, and a frozen frame to study it.
Ultra-V, infra-red, scratch-detect, edge and negative image modes bring out what the eye misses.
A boxed flaw is sized on the spot — a line by its length and width, a dot by its diameter — and classed major, minor or micro.
Each mark is placed on the card and counted against its corner, edge or surface on the score sheet.
The angle of every corner is measured from the card’s own edges, to a hundredth of a degree. One that cannot be read from the capture is shown as an estimate (≈).
Every edge of both faces is cut from the full-resolution scan into a strip you can read end to end.
When the inspection is finished the report is built and published: to BLACKVAULT for anyone holding the card and to BLACKBOARD for the population — and the customer hears about it by email.
Every card we inspect goes through BLACKLENS 3.3.